4248506323
Change-Id: I5df78a9070b4bb136f570a889a3f578d8ee82088 Signed-off-by: Zhijiang Hu <hu.zhijiang@zte.com.cn>
32 lines
1.3 KiB
Plaintext
32 lines
1.3 KiB
Plaintext
Configuration Guide
|
|
===================
|
|
|
|
Before installing Daisy on jump server, you have to configure the
|
|
daisy.conf file, then put it in /home/daisy_install/.
|
|
|
|
1. you have to supplement the "daisy_management_ip" field with the ip of
|
|
management ip of your Daisy server vm.
|
|
|
|
2. Now the backend field "default_backend_types" just support the "kolla".
|
|
|
|
3. "os_install_type" field just support "pxe" for now.
|
|
|
|
4. Daisy now use pxe server to install the os, so "build_pxe" must set to "yes".
|
|
If the value in daisy.conf in your env of /home/daisy_install/ dir is "no",
|
|
you must change this field to "yes" manually before installing Daisy.
|
|
|
|
5. "eth_name" field is the pxe server interface, and this field is required when
|
|
the "build_pxe" field set to "yes".This should be set to the interface
|
|
(in Daisy Server VM) which will be used for communicating with other target nodes
|
|
on management/PXE net plane. Default is ens3.
|
|
|
|
6. "ip_address" field is the ip address of pxe server interface.
|
|
|
|
7. "net_mask" field is the netmask of pxe server, which is required when the "build_pxe"
|
|
is set to "yes"
|
|
|
|
8. "client_ip_begin" and "client_ip_end" field are the dhcp range of the pxe server.
|
|
|
|
9. If you want to use the multicast type to deliver the kolla image to target node,
|
|
set the "daisy_conf_mcast_enabled" field to "True"
|