kolla-ansible/doc/ironic-guide.rst
Jeff Peeler f5a50a1d7d Add Ansible support for Ironic
Configuration based off upstream documentation here:
http://docs.openstack.org/developer/ironic/deploy/install-guide.html

A few notes:
-ironic-api is not configured to use mod_wsgi
-several places it's noted that discoverd is going away and needs to be
replaced with ironic-inspector - (sqlite connection should be changed
too)
-currently enabling ironic reconfigures nova compute (driver and
scheduler) as well as changes neutron network settings
-a nice enhancement would be to configure the web console

Required post-deployment configuration:

Create the flat network to launch the instances:

neutron net-create --tenant-id $TENANT_ID sharednet1 --shared \
--provider:network_type flat --provider:physical_network physnet1

neutron subnet-create sharednet1 $NETWORK_CIDR --name $SUBNET_NAME \
--ip-version=4 --gateway=$GATEWAY_IP --allocation-pool \
start=$START_IP,end=$END_IP --enable-dhcp

And then the above ID is used to set cleaning_network_uuid in the neutron
section of ironic.conf.

Change-Id: I572e7ff1f23c4e57a2c50817cafe9269fd9950dd
Implements: blueprint ironic-container
2015-09-28 16:10:43 -04:00

1.3 KiB

Ironic in Kolla

Overview

Currently Kolla can deploy the Ironic services:

  • ironic-api
  • ironic-conductor
  • ironic-discoverd

As well as a required PXE service, deployed as ironic-pxe.

Current status

The Ironic implementation is "tech preview", so currently instances can only be deployed on baremetal. Further work will be done to allow scheduling for both virtualized and baremetal deployments. Most probably at that time discoverd will be replaced by ironic-inspector.

Post-deployment configuration

Configuration based off upstream documentation.

Again, remember that enabling Ironic reconfigures nova compute (driver and scheduler) as well as changes neutron network settings. Further neutron setup is required as outlined below.

Create the flat network to launch the instances: :

neutron net-create --tenant-id $TENANT_ID sharednet1 --shared \
--provider:network_type flat --provider:physical_network physnet1

neutron subnet-create sharednet1 $NETWORK_CIDR --name $SUBNET_NAME \
--ip-version=4 --gateway=$GATEWAY_IP --allocation-pool \
start=$START_IP,end=$END_IP --enable-dhcp

And then the above ID is used to set cleaning_network_uuid in the neutron section of ironic.conf.