docs/doc/source/storage/kubernetes/increase-the-size-for-lvm-local-volumes-on-controller-filesystems.rst

Increase the Size for LVM Local Volumes on Controller Filesystems

Controller filesystems are allocated as LVM local volumes inside the cgts-vg volume group. You can increase controller filesystem storage inside the cgts-vg volume group by using the , or the Horizon Web interface.

To provision filesystem storage, enough free disk space has to be available in this volume group. You can increase available space for provisioning by creating a partition and assigning it to cgts-vg volume group. This partition can be created on the root disk or on a different disk of your choice. In , Simplex or Duplex systems that use a dedicated disk for nova-local, some root disk space reserved for nova-local is unused. You can recover this space for use by the cgts-vg volume group to allow for controller filesystem expansion.

For convenience, this operation is permitted on an unlocked controller.

Note

Using more than one disk during setup for cgts-vg, may increase disk failures. In case any of the disks in the cgts-vg volume group fails, the disk has to be replaced and the node has to be reinstalled. It is strongly recommended to limit cgts-vg to the root disk.

Note

The partition should be the same size on both controllers, otherwise only the smallest common denominator size can be provisioned from cgts-vg.

Caution

Once the cgts-vg partition is added, it cannot be removed.

The following example is used for provisioning cgts-vg on a root disk. The default rootfs device is /dev/sda.

1. Check the free space on the rootfs, by using the following command:

   ~(keystone_admin)$ system host-disk-list 1

2. Create a new partition on rootfs, for example:

   ~(keystone_admin)$ system host-disk-partition-add -t lvm_phys_vol controller-0 /dev/sda 22
    +---------------+------------------------------------------------+
    | Property      |     Value                                      |
    +---------------+------------------------------------------------+
    | device_path   |/dev/disk/by-path/pci-0000:00:0d.0-ata-1.0-part7|
    | device_node   | /dev/sda7                                      |
    | type_guid     | ba5eba11-0000-1111-2222-000000000001           |
    | type_name     | None                                           |
    | start_mib     | None                                           |
    | end_mib       | None                                           |
    | size_mib      | 22528                                          |
    | uuid          | 994d7efb-6ac1-4414-b4ef-ae3335dd73c7           |
    | ihost_uuid    | 75ea78b6-62f0-4821-b713-2618f0d5f834           |
    | idisk_uuid    | 685bee31-45de-4951-a35c-9159bd7d1295           |
    | ipv_uuid      | None                                           |
    | status        | Creating                                       |
    | created_at    | 2020-07-30T21:29:04.014193+00:00               |
    | updated_at    | None                                           |
    +---------------+------------------------------------------------+

3. Check the disk space on the new partition, once it is created.

   ~(keystone_admin)$ system host-disk-partition-list 1
   ---------------------------------------------------------------------------------
    uuid    device_path         device_node type_guid  type_name    size_gib status
   ---------------------------------------------------------------------------------
    69b1b.. /dev/disk/by-path/.. /dev/sda6  ba5eba11.. LVM Phy.Vol..  22.0  Ready
   ---------------------------------------------------------------------------------

4. Assign the unused partition on controller-0 as a physical volume to cgts-vg volume group.

   For example

   ~(keystone_admin)$ system host-pv-add controller-0 cgts-vg 69b1bb35-7326-4bcc-94d7-bef72f064f46
   +---------------------------+---------------------------------------+
   |    Property               | Value                                 |
   +---------------------------+---------------------------------------+
   | uuid                      | 626c450f-4472-485c-bae7-791768630e1e  |
   | pv_state                  | adding                                |
   | pv_type                   | partition                             |
   | disk_or_part_uuid         | 69b1bb35-7326-4bcc-94d7-bef72f064f46  |
   | disk_or_part_device_node  | /dev/sda6                             |
   | disk_or_part_device_path  | /dev/disk/by-path/pci-0000:18:00.     |
   |                           | 0-scsi-0:2:0:0-part6                  |
   | lvm_pv_name               | /dev/sda6                             |
   | lvm_vg_name               | cgts-vg                               |
   | lvm_pv_uuid               | None                                  |
   | lvm_pv_size_gib           | 0.0                                   |
   | lvm_pe_total              | 0                                     |
   | lvm_pe_alloced            | 0                                     |
   | ihost_uuid                | e579a4af-108b-4dc9-9975-0aa089d530d7  |
   | created_at                | 2020-12-09T17:22:19.666250+00:00      |
   | updated_at                | None                                  |
   +---------------------------+---------------------------------------+

5. To assign the unused partition on controller-1 as a physical volume to cgts-vg volume group, swact the hosts and repeat the procedure on controller-1.

After increasing the cgts-vg volume size, you can provision the filesystem storage. For more information about increasing filesystem allotments using the , or the Horizon Web interface, see:

• Increase Controller Filesystem Storage Allotments Using Horizon <increase-controller-filesystem-storage-allotments-using-horizon>
• Increase Controller Filesystem Storage Allotments Using the CLI <increase-controller-filesystem-storage-allotments-using-the-cli>